![]() #Coppercube tutorial archiveTurn Off Automatic Selection of All Trend Logs when the Automatic Trend Log Selection box is selected, CopperCube will automatically discover and archive all trend logs it finds on the site. This setup information is used to ensure that data from CopperCube is mapped to the correct building in Kaizen. This site name will also need to be entered into Kaizen so that your Kaizen account presents the correct data. See Sites for information on defining your site(s). The site provides a definition for the CopperCube software to be able to connect to the BACnet network and retrieve data. Settings > Sites and Device Ranges: You must have the CopperCube connected by the BACnet port to the building control network to configure the Sites and Devices. If the setup is correct, you should see the status page of the CopperCube graphical user interface (UI).ĬopperCube IP configurations found under IP settings tab of the settings page 5: Add a site ![]() Open a web browser and enter 169.254.8.29 into the address bar.Please note that the CopperCubes purchased prior to March 1, 2014, has a different fixed-IP. Plug a Cat5e cable into your computer’s network port and then into and into the CopperCube fixed-IP Service port (labeled LAN 2).When the CopperCube starts up, it will produce a short beep. ![]() Check the Power LED and if it is not on, press and hold the power button until the green power light turns on.Part numbers are 194300 (North America) and 194301 (European) If you did not order a power supply and require one, they are available through online ordering. Connect 24VAC/50VA to the 2-pin screw terminal or 12-28VDC/30W through the barrel connector of a power supply to the CopperCube.The following steps can be taken to set up CopperCubes: 1: Physical Set-Up ![]() This document describes the steps that need to be done in order to set up your CopperCube so that it can collect data from your BACnet network. Your CopperCube has come from the factory in an unconfigured state. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |